Bulletin #4

What is the difference between single-rate battery chargers and two-rate chargers?  Is there a benefit to one over the other?

Generator set battery systems are very important for many reasons.  Their reliability is of much importance when critical loads are a factor.  While the battery and charger work together to insure uninterrupted power, the battery is ultimately responsible for reliable engine starts.   If the battery fails your generator might not start resulting in lack of power to equipment and facilities.

It is the battery charger's duty to maintain fully charged batteries at all times to assure positive engine starts under routine or emergency conditions.  The battery charger is designed to provide the batteries with a charging current anytime the charge level falls below acceptable limits.  There are many designs of battery chargers, but most operate under one of the following two concepts:

1. Single-Rate Charger - Also known as "trickle charger", this unit will produce its maximum current for only a very short time, then begins to taper off as the batteries' state of charge increases.   The only way to maintain a higher current output into the battery would be to increase the charger's output voltage.  This, however, would cause serious overcharging problems as the battery becomes fully charged.  Thus, the voltage chosen for any single-rate charger is a compromise between fast charging and optimum battery maintenance voltage.  The most common problem with the single-rate charger is the loss of electrolyte in batteries caused by a "boiling" effect as they are overcharged.  This leads to extensive labor hours replacing or servicing batteries.   It should also be noted that due to their nature, most single-rate chargers sold as "5 amp" never reach full current output and therefore may offer the performance of a 2 amp charger!

2. Two-Rate Charger - Also known as "float chargers", the two-rate charger automatically operates at a "boost" charging voltage that allows the battery to draw the charger's maximum output until is almost fully charged.  When the battery reaches a high rate of charge, the charger shifts to the optimum float voltage to minimize battery electrolyte consumption.   Since the charger monitors the battery 100% of the time, the optimum charge is provided without adjustments.  The correct two-rate battery charger will offer faster charging performance and will reduce the requirement for maintenance.  No compromise is made.

The benefits of the two-rate battery charger make for a much more reliable battery system.  However, attention must be given to the various designs out in the marketplace.  The minimum requirements should include: (a) temperature compensation which insures correct charging in most conditions, (b) output voltage regulation to maintain rated output regardless of input volts and frequency variations, (c) current limiting and (d) overload protection.

Davidson Sales Company represents Stored Energy Systems (SENS) two-rate battery chargers.  This line of chargers features "Autoboost" and meets all requirements depicted above to provide with a reliable battery charging system.  For information on SENS battery chargers, contact us for literature through our Literature Request Form.

Mailing Address: P.O. Box 9086, Daytona Beach, Florida 32120-9086 USA

Ship To Address: 839 Bill France Blvd, Daytona Beach, Florida 32117

Phone (386) 274-2079   Fax (386) 274-2279

Contact Us